crank arm

英 [kræŋk ɑːm]

美 [kræŋk ɑːrm]

网络  曲柄臂; 曲臂; 曲柄

机械

双语例句

• Computer Simulation of A Complex Crank Rocker Arm Mechanism Moving
  一种复杂曲柄摇杆机构运动学的计算机仿真
• The crankshafts shown in Fig1-4 is actually made up of various parts such as main bearing journals, rod journal, crank arm, bearing, counter balanced weight and flywheel end.
  在图1-4中，曲轴实际上由以下不同的部分组成，它们分别是：主轴承轴颈、连杆轴颈、曲轴臂、轴承、平衡配量（？）以及飞轮端。
• The utility model is composed of a land wheel, a driving pin, a driving crank arm, a driving inserted link, a release spring, and a driving ratchet.
  它由地轮、传动销、传动拐臂、传动插杆、回位弹簧和传动棘轮组成。
• Begin with the analysis and the investigation of the basic principle chart of illustrated diagram method of type ⅰ and ⅱ institution of plane crank jointed arm which is designed according to the stroke velocity ratio coefficient.
  从分析、考察按行程速比系数K设计ⅠI型、Ⅱ型平面曲柄摇杆机构图解法的基本原理图入手，对最佳辅助角λ（？）
• The RW Series Rotary Actuator design utilizes two independent piston cylinders, each piston has a crank arm attached to a crankshaft.
  在RW系列旋转式驱动器设计采用两个独立的活塞筒，每个活塞有曲柄连接曲轴臂。
• Affix using one of the crank arm fixing bolts.
  词缀使用其中的一个曲柄臂固定螺栓。
• Turn the wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft.
  转动雨刷模组盖，并拆下将雨刷马达曲柄臂固定于雨刷马达输出轴上的螺帽。
• With the third steps and the fourth steps natural frequency vibration, the smaller close to the second crank arm of crankshaft and round place natural frequency of the main shaft transition the position is.
  以第3阶和第4阶固有频率振动，位置越靠近曲轴第二个曲柄臂与主轴过渡圆处固有频率越小。
• To raise the polishing efficiency of Cubic boron nitride ( CBN) superhard material, crank rocker arm mechanism has been developed by using Computer Simulation Technology.
  为了提高立方氮化硼超硬材料的抛光效率，采用计算机仿真技术开发了曲柄摇杆抛光机构。
• Crank and Rocker Arm Shear's Kinematics Analysis Based on Matlab
  基于Matlab的曲柄摇杆式飞剪运动学分析研究